Wilo HiControl 1-EK electronic control and monitoring system

Electronic control and regulating accessories. The Wilo-HiControl 1 series is used for clear water pumps to enable automatic operation. Wilo-HiControl 1 protects the pump from low-flow operation. Thanks to a flow sensor and a pressure sensor, Wilo-HiControl 1 automates the pump between two values: the cut-in pressure and the cut-off flow rate. If the pressure in the network is lower than the cut-in pressure, Wilo-HiControl 1 starts the pump. The pump operates until the flow rate falls below the cut-off flow rate value. The internal, small tank prevents water hammer and cycling. The Wilo-HiControl 1-EK version, with an electrical cable and integrated socket, shortens installation time through direct connection to the pump and power supply. Wilo-HiControl 1 can be mounted on surface pumps or connected to submersible motor pumps for domestic water supply. Special features Easy installation Suitable for many applications due to its particularly compact design High operational reliability due to electronic fault message Protection of connected pumps by integrated dry-run protection Simple operation thanks to clear operating status display No additional diaphragm pressure tank required Perfect corrosion protection due to stainless materials Pre-wired for fastest installation. Inline version with inlet and outlet in vertical axis and uniform threaded connections, suitable for direct connection to the pump housing or for wall mounting using a wall bracket (accessory). Note The HiControl 1 must only be installed in a vertical position with the outlet at the top! Scope of delivery HiControl 1 EK incl. 1.5 m connection cable with intermediate plug EK Cable ties for quick and secure installation of plug-and-play pump units