Separator 15 opening A 8-60mm f.Item no. 41 57 490 000 KUKKO

Application: for removing ball bearings, roller bearings, inner rings and other flush-fitting parts · the sharp cutting edges enable the removal of flush-fitting parts where 2- and 3-arm pullers are unsuitable (Fig. 1) · the separating jaws are clamped by evenly tightening the nuts on the side bolts. Method of operation: removal is achieved by tightening the spindle against the shaft end (Figures 2 and 3); hydraulic operation is also possible with the larger pulling devices. Hydraulic operation (Figure 4): (hydraulics not included in scope of delivery) screw the spindle of the hydraulics into the thread of the puller's cross-beam using wrench (b) · until the pressure piece presses firmly against the shaft, then activate the hydraulics by turning the upper spindle (a) · Note: Figures 2 and 3 show the separating device in combination with puller Art. No. 4157 490 000, 4157 490 001, 4157 490 002, 4157 490 003 (not included in scope of delivery). Figure 4 shows the separating device in combination with puller Art. No. 4157 490 000, 4157 490 001, 4157 490 002, 4157 490 003 and a hydraulic spindle (puller and hydraulic spindle not included in scope of delivery). Please inquire about hydraulic spindle separately. Further technical properties: · Weight: 0.69 kg