Abrasive Sleeve KSB D45xB30mm Grit 50 Corundum A max. speed 12700 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · supplied without rubber holder · Drive type: Straight grinder · Flexible shaft drive · Application recommendation: Use a grinding oil suitable for the material to significantly increase the tool life and grinding performance of the tools. For easy changing of the abrasive sleeves, pull them on and off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For best performance, use at a recommended cutting speed of 20-30 m/s. · Workable materials: Steels up to 1,200 N/mm² (54 HRC, stainless steel (INOX)), hardened, tempered steels over 1,200 N/mm² (< 38 HRC), gray/ductile cast iron (GG/GJL, GGG/GJS), fiber-reinforced duroplastics (GRP, CFRP), aluminum, copper, cast steel, bronze, brass, malleable cast iron, thermoplastics, cobalt-based alloys · Processing tasks: Edge processing, deburring, step-by-step fine grinding, leveling, roughening, sharpening, weld seam processing, surface processing · Ordering notes: Please order abrasive sleeve holders separately. · Inner Ø: 45mm · RPM · opt. · up to: 12700RPM · RPM · opt. · from: 8500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Outstanding tool life due to special manufacturing process – even under the harshest operating conditions. Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use.