Grinding sleeve KSB D25xB25mm grit 150 aluminum oxide max. speed 22900 rpm PFERD

Corundum A · For universal use from coarse to fine grinding · Supplied without rubber holder · Drive type: Flexible shaft drive, Straight grinder · Application recommendation: For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For best performance, use at a recommended cutting speed of 20-30 m/s. Use a grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For easy changing of the abrasive sleeves, slide them on and off with a slight right-hand turn. Leave the abrasive sleeve holder clamped in the tool drive. · Machinable materials: Cobalt-based alloys, Grey/nodular cast iron (GG/GJL, GGG/GJS), Aluminum, Malleable cast iron, Brass, Bronze, Cast steel, Fiber-reinforced thermoplastics (GRP, CFRP), Thermoplastics, Hardened, tempered steels over 1,200 N/mm² (54 HRC), Steels up to 1,200 N/mm² (< 38 HRC), Copper · Processing tasks: Leveling, Progressive fine grinding, Roughening, Surface processing, Edge processing, Weld seam processing, Deburring, Sharpening · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 25mm · RPM, opt., up to: 22900RPM · RPM, opt., from: 16000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Outstanding service life due to special manufacturing process – even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder by expansion of the holder during use. Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive.