Sanding sleeve KSB D19xB25mm grit 80 corundum A max. speed 30000 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · supplied without rubber holder · Drive type: Straight grinder · Flexible shaft drive · Recommended application: To easily change abrasive sleeves, slide them on and off with a slight right-hand turn. Leave the abrasive sleeve holder clamped in the tool drive. Use an abrasive oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. · Workable materials: Fiber-reinforced thermosets (GRP · CFRP) · Aluminum · Malleable cast iron · Brass · Bronze · Cast steel · Copper · Gray/spheroidal cast iron (GG/GJL · GGG/GJS) · Hardened · tempered steels over 1,200 N/mm² ( 54 HRC, steels up to 1,200 N/mm² (< 38 HRC)), Thermoplastics, Cobalt-based alloys · Processing tasks: Edge processing, Leveling, Step-by-step fine grinding, Deburring, Roughening, Sharpening, Weld seam processing, Surface processing · Ordering information: Please order abrasive sleeve holders separately. · Ø Inner: 19mm · RPM · opt. · up to: 30000RPM · RPM · opt. · from: 20000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to extend beyond the abrasive sleeve holder. · Advantages: Maximum economic efficiency due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process – even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder by expansion of the holder during use.