Abrasive Sleeve KSB D19xB25mm Grit 150 Corundum A max. speed 30000 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · Supplied without rubber backing pad · Drive type: straight grinder · flexible shaft drive · Application recommendation: To easily change the abrasive sleeves, pull them on and off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For best performance, use at a recommended cutting speed of 20-30 m/s. · Workable materials: Fiber-reinforced thermosets (GRP, CFRP), copper, aluminum, malleable cast iron, brass, bronze, cast steel, thermoplastics, gray/spheroidal cast iron (GG/GJL, GGG/GJS), hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC), cobalt-based alloys · Processing tasks: Surface processing, edge processing, weld seam processing, sharpening, leveling, gradual fine grinding, deburring, roughening · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 19mm · RPM · opt. · up to: 30000RPM · RPM · opt. · from: 20000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Outstanding service life due to special manufacturing process – even under the toughest operating conditions.