Abrasive sleeve KSB D13xB25mm grit 80 corundum A max. speed 44000 min-¹ PFERD

Corundum A · for universal use from coarse to fine grinding · supplied without rubber backing pad · Drive type: straight grinder, flexible shaft drive · Application recommendation: For best performance, use at a recommended cutting speed of 20-30 m/s. Use suitable grinding oil for the material to significantly increase the service life and grinding performance of the tools. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of the abrasive sleeves, attach and remove them with a slight right-hand turn. The abrasive sleeve holder should remain clamped in the tool drive. · Workable materials: Gray/spheroidal cast iron (GG/GJL, GGG/GJS), malleable cast iron, brass, bronze, cast steel, cobalt-based alloys, aluminum, hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC), thermoplastics, copper, fiber-reinforced thermosets (GRP, CFRP) · Machining tasks: Roughening, deburring, leveling, surface machining, gradual fine grinding, weld seam machining, edge machining, sharpening · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 13mm · RPM, opt., up to: 44000RPM · RPM, opt., from: 30000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Outstanding service life due to special manufacturing process – even under the toughest operating conditions.