Abrasive sleeve GSB D60xB30mm grit 50 corundum A max. speed 9500 rpm PFERD

Corundum A · For universal use from rough to fine grinding · Supplied without rubber backing pad · Drive type: Flexible shaft drive, Straight grinders · Recommended application: For best performance, use at a recommended cutting speed of 20-30 m/s. To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For easy changing of the abrasive sleeves, pull them on and off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. · Workable materials: Steels up to 1,200 N/mm² (54 HRC), stainless steel (INOX), hardened, tempered steels over 1,200 N/mm² (< 38 HRC), gray/spheroidal cast iron (GG/GJL, GGG/GJS), thermoplastics, cast steel, fiber-reinforced thermosets (GRP, CFRP), bronze, brass, malleable cast iron, aluminum, copper, cobalt-based alloys · Processing tasks: Roughening, deburring, edge processing, weld seam processing, surface processing, sharpening, stepwise fine grinding, leveling · Ordering notes: Please order abrasive sleeve holders separately. · Inner Ø: 60mm · RPM, opt., up to: 9500RPM · RPM, opt., from: 6500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Maximum economic efficiency due to exceptionally high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process - even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder by expansion of the holder during use.