Sanding sleeve GSB D45xB30mm 30 mm grit 50 Corundum A max. speed 12700 min-¹ PF

Corundum A · For universal use from coarse to fine grinding · Supplied without rubber holder · Drive type: Die grinder, Flexible shaft drive · Recommended application: Use a grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of the abrasive sleeves, attach and remove them with a slight right-hand turn. Leave the abrasive sleeve holder clamped in the tool drive. For best performance, use at a recommended cutting speed of 20-30 m/s. · Workable materials: Brass, Thermoplastics, Aluminum, Malleable cast iron, Bronze, Cobalt-based alloys, Copper, Fiber-reinforced thermoplastics (GRP, CFRP), Gray/spheroidal cast iron (GG/GJL, GGG/GJS), Hardened, tempered steels over 1,200 N/mm² (54 HRC), Cast steel, Steels up to 1,200 N/mm² (< 38 HRC) · Processing tasks: Edge machining, Step-by-step fine grinding, Leveling, Roughening, Sharpening, Surface machining, Weld seam machining, Deburring · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 45mm · RPM, opt., up to: 12700RPM · RPM, opt., from: 8500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not let abrasive sleeves protrude beyond the abrasive sleeve holder. · Advantages: Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Secure fit of the abrasive sleeve on the abrasive sleeve holder by expansion of the holder during use. Outstanding service life due to special manufacturing process – even under the toughest operating conditions.