Sanding sleeve GSB D45xB30mm 30 mm K 80 Zirconia Alumina Z max. speed 12700 min-¹ PFERD

for coarse grinding tasks with high material removal rate and tool life · GSB = bulk pack abrasive sleeves · Supplied without rubber backing pad · Drive type: flexible shaft drive · Straight grinder · Application recommendation: Use grinding oil suitable for the material to significantly increase the tool life and grinding performance. For easy changing of the abrasive sleeves, push them on and pull them off with a slight right-hand turn. Leave the abrasive sleeve holder clamped in the tool drive. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For best performance, use at a recommended cutting speed of 20-30 m/s. · Machinable materials: Titanium, hardened, tempered steels over 1,200 N/mm² (54 HRC), Machining tasks: Step-by-step fine grinding, edge machining, weld seam machining, surface machining, sharpening, deburring, levelling, roughening · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 45mm · RPM · opt. · up to: 12700RPM · RPM · opt. · from: 8500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The stated maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Outstanding tool life due to special manufacturing process – even under the toughest operating conditions. Maximum cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive.