Abrasive sleeve GSB D45xB30mm 30 mm K 60 Zirconia Alumina Z max. speed 12700 min-¹ PFERD

for rough grinding tasks with high stock removal rate and tool life · GSB = bulk pack abrasive sleeves · Supplied without rubber holder · Drive type: straight grinder · flexible shaft drive · Application recommendation: For best performance, use at a recommended cutting speed of 20-30 m/s. Use a grinding oil suitable for the material to significantly increase the tool life and grinding performance of the tools. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of the abrasive sleeves, push them on and pull them off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. · Workable materials: Steels up to 1,200 N/mm² (54 HRC, stainless steel (INOX)), Hardened, tempered steels over 1,200 N/mm² (< 38 HRC), Gray/spheroidal cast iron (GG/GJL, GGG/GJS), Copper, Cobalt-based alloys · Processing tasks: Weld seam processing, Deburring, Edge processing, Surface processing, Sharpening, Roughening, Progressive fine grinding, Leveling · Ordering notes: Please order abrasive sleeve holders separately. · Ø inner: 45mm · RPM · opt. · to: 12700RPM · RPM · opt. · from: 8500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The stated maximum permissible speed must never be exceeded for safety reasons. Do not let abrasive sleeves protrude beyond the abrasive sleeve holder. · Advantages: Outstanding tool life due to special manufacturing process – even under the toughest operating conditions. Maximum cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Secure fit of the abrasive sleeve on the abrasive sleeve holder by expansion of the holder during use.