Abrasive Sleeve GSB D45xB30mm 30 mm K 40 Zirconia Alumina Z max. RPM 12700 PFERD

for coarse grinding tasks with high material removal rates and tool life · GSB = bulk pack abrasive sleeves · Supplied without rubber holder · Drive type: Flexible shaft drive · Straight grinder · Application recommendation: To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of the abrasive sleeves, pull them on and off with a slight clockwise rotation. Leave the abrasive sleeve holder clamped in the tool drive. Use an appropriate grinding oil for the material to significantly increase the tool life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. · Workable materials: Steel materials with a hardness > 54 HRC, Hardened, tempered steels over 1,200 N/mm² (< 38 HRC), Cast steel, Steels up to 1,200 N/mm² (< 38 HRC), Stainless steel (INOX), Malleable cast iron, Brass, Gray/Spheroidal cast iron (GG/GJL, GGG/GJS), Bronze, Copper, Cobalt-based alloys, Titanium · Processing tasks: Edge processing, Step-by-step fine grinding, Surface processing, Sharpening, Roughening, Leveling, Weld seam processing, Deburring · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 45mm · RPM · opt. · up to: 12700RPM · RPM · opt. · from: 8500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. For safety reasons, the stated maximum permissible speed must never be exceeded. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Outstanding tool life due to a special manufacturing process – even under the toughest operating conditions. Maximum cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use.