Grinding Sleeve GSB D30xB30mm Grit 50 Corundum A max. speed 19100 rpm PFERD

Aluminum oxide A · For universal use from coarse to fine grinding · Supplied without rubber holder · Drive type: Die grinder, Flexible shaft drive · Application recommendation: To change the abrasive sleeves easily, twist them on and off with a slight clockwise rotation. Leave the abrasive sleeve holder clamped in the tool drive. For best performance, use at a recommended cutting speed of 20-30 m/s. Use a grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. · Workable materials: Brass, Thermoplastics, Steels up to 1,200 N/mm² (54 HRC), Stainless steel (INOX), Hardened, tempered steels over 1,200 N/mm² (< 38 HRC), Gray/spheroidal cast iron (GG/GJL, GGG/GJS), Fiber-reinforced thermosets (GRP, CFRP), Copper, Aluminum, Bronze, Cast steel, Malleable cast iron, Cobalt-based alloys · Processing tasks: Edge processing, Surface processing, Leveling, Step-by-step fine grinding, Sharpening, Deburring, Weld seam processing, Roughening · Ordering information: Please order abrasive sleeve holders separately. · Inner diameter: 30mm · RPM, opt., up to: 19100RPM · RPM, opt., from: 13000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Abrasive sleeves must not protrude beyond the abrasive sleeve holder. · Advantages: Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Outstanding service life due to special manufacturing process – even under the toughest operating conditions.