Grinding sleeve D60xB30mm grit 60 Aluminum oxide A max. speed 9500 rpm PFERD

Corundum A · For universal use from coarse to fine grinding · Supplied without rubber carrier · Drive type: Flexible shaft drive, straight grinder · Recommended application: For best performance, use at a recommended cutting speed of 20-30 m/s. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve carrier. For easy changing of the abrasive sleeves, pull them on and off with a slight right-hand rotation. Leave the abrasive sleeve carrier clamped in the tool drive. Use an abrasive oil suitable for the material to significantly increase the tool life and grinding performance of the tools. · Workable materials: Brass, steel materials with a hardness > 54 HRC, hardened, tempered steels over 1,200 N/mm² (< 38 HRC), gray/ductile cast iron (GG/GJL, GGG/GJS), fiber-reinforced thermosets (GFRP, CFRP), copper, cobalt-based alloys, aluminum, bronze, malleable cast iron, steels up to 1,200 N/mm² (< 38 HRC), cast steel, stainless steel (INOX), thermoplastics · Machining tasks: Surface machining, sharpening, roughening, leveling, edge machining, stepwise fine grinding, deburring, weld seam machining · Ordering information: Please order abrasive sleeve carriers separately. · Inner Ø: 60mm · RPM, opt., up to: 9500RPM · RPM, opt., from: 6500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve carrier. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve carrier due to expansion of the carrier during use. Highest economic efficiency due to particularly high material removal and high aggressiveness of the abrasive. Outstanding tool life due to special manufacturing process – even under the toughest operating conditions.