Abrasive sleeve D45xB30mm grit 40 corundum A max. speed 12700 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · supplied without rubber holder · Drive type: Straight grinder, flexible shaft drive · Application recommendation: To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of the abrasive sleeves, pull them on and off with a slight clockwise rotation. Leave the abrasive sleeve holder clamped in the tool drive. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. · Workable materials: Thermoplastics, malleable cast iron, brass, bronze, cast steel, cobalt-based alloys, copper, fiber-reinforced thermosets (GRP, CFRP), gray/spheroidal cast iron (GG/GJL, GGG/GJS), hardened, tempered steels over 1,200 N/mm² (> 54 HRC), steels up to 1,200 N/mm² (< 38 HRC), aluminum · Machining tasks: Surface machining, sharpening, roughening, leveling, weld seam machining, edge machining, deburring, progressive fine grinding · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 45mm · RPM, opt., up to: 12700RPM · RPM, opt., from: 8500RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The stated maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process - even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder by expansion of the holder during use.