Abrasive sleeve D30xB30mm grit 80 corundum A max. speed 19100 rpm PFERD

Corundum A · For universal use from coarse to fine grinding · Supplied without rubber holder · Drive type: straight grinder, flexible shaft drive · Application recommendation: For easy changing of abrasive sleeves, slide them on and off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. For best performance, use at a recommended cutting speed of 20-30 m/s. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. · Machinable materials: Aluminum, brass, malleable cast iron, bronze, cast steel, thermoplastics, cobalt-based alloys, copper, stainless steel (INOX), fiber-reinforced thermosets (GRP, CFRP), hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC), gray/ductile cast iron (GG/GJL, GGG/GJS) · Machining tasks: Leveling, deburring, progressive fine grinding, roughening, sharpening, surface machining, edge machining, weld seam machining · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 30mm · RPM, opt., up to: 19100RPM · RPM, opt., from: 13000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Maximum economic efficiency due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process – even under the toughest operating conditions.