Abrasive sleeve D30xB30mm grit 60 corundum A max. speed 19100 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · Supplied without rubber backing pad · Drive type: Straight grinder, flexible shaft drive · Recommended application: Use a grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. For easy changing of the abrasive sleeves, push them on and pull them off with a slight clockwise rotation. Leave the abrasive sleeve holder clamped in the tool drive. To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. · Workable materials: Aluminium, brass, bronze, cast steel, copper, hardened, tempered steels over 1,200 N/mm² (54 HRC), cobalt-based alloys, stainless steel (INOX), grey/spheroidal graphite cast iron (GG/GJL, GGG/GJS) · Processing tasks: Weld seam processing, gradual fine grinding, leveling, roughening, surface processing, deburring, edge processing, sharpening · Ordering information: Please order abrasive sleeve holders separately. · Inner diameter: 30mm · RPM, opt., up to: 19100RPM · RPM, opt., from: 13000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Outstanding service life due to special manufacturing process – even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder by expansion of the holder during use. Highest economic efficiency due to particularly high material removal and high aggressiveness of the abrasive.