Abrasive Sleeve D30xB30mm Grit 40 Corundum A max. speed 19100 rpm PFERD

Corundum A · For universal use from coarse to fine grinding · Supplied without rubber holder · Drive type: Die grinder, flexible shaft drive · Recommended application: For easy changing of abrasive sleeves, twist them on and off with a slight right-hand turn. Leave the abrasive sleeve holder clamped in the tool drive. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. Use grinding oil suitable for the material to significantly increase the tool life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. · Workable materials: Bronze, brass, aluminum, malleable cast iron, fiber-reinforced thermosets (GRP, CFRP), copper, grey/spheroidal cast iron (GG/GJL, GGG/GJS), hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC), thermoplastics, cast steel, cobalt-based alloys · Processing tasks: Deburring, leveling, roughening, sharpening, surface processing, weld seam processing, edge processing, progressive fine grinding · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 30mm · RPM, opt., up to: 19100RPM · RPM, opt., from: 13000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The stated maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Outstanding tool life due to special manufacturing process – even under the toughest operating conditions. Highest economic efficiency due to particularly high material removal and high aggressiveness of the abrasive.