Abrasive sleeve D22xB20mm Grit 150 Corundum A max. speed 26000 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · Supplied without rubber backing pad · Drive type: flexible shaft drive, straight grinder · Recommended application: Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For easy changing of the abrasive sleeves, pull them on and off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For best performance, use at a recommended cutting speed of 20-30 m/s. · Machinable materials: Grey/ductile cast iron (GG/GJL, GGG/GJS), bronze, aluminium, steels up to 1,200 N/mm² (54 HRC, hardened, tempered steels over 1,200 N/mm² (< 38 HRC), thermoplastics, fibre-reinforced thermosets (GRP, CFRP), copper, cobalt-based alloys, malleable cast iron, brass, cast steel, stainless steel (INOX) · Processing tasks: Step-by-step fine grinding, deburring, edge processing, weld seam processing, surface processing, sharpening, roughening, levelling · Ordering information: Please order abrasive sleeve holders separately. · Ø Inner: 22mm · RPM, opt., to: 26000RPM · RPM, opt., from: 18000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Highest efficiency due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process – even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use.