Abrasive sleeve D15xB30mm grit 80 corundum A max. speed 36000 rpm PFERD

Corundum A · For universal use from coarse to fine grinding · Supplied without rubber holder · Drive type: Die grinder, Flexible shaft drive · Recommended application: For best performance, use at a recommended cutting speed of 20-30 m/s. Use grinding oil suitable for the material to significantly increase the tool's service life and grinding performance. To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of abrasive sleeves, mount and remove them with a slight right-hand turn. Leave the abrasive sleeve holder clamped in the tool drive during this process. · Workable materials: Steel materials with a hardness > 54 HRC, Aluminum, Malleable cast iron, Brass, Bronze, Cast steel, Cobalt-based alloys, Copper, Fiber-reinforced thermoplastics (GRP, CFRP), Grey/Spheroidal cast iron (GG/GJL, GGG/GJS), Stainless steel (INOX), Steels up to 1,200 N/mm² (< 38 HRC), Thermoplastics, Hardened, tempered steels over 1,200 N/mm² (< 38 HRC) · Processing tasks: Sharpening, Surface finishing, Weld seam processing, Edge processing, Deburring, Step-by-step fine grinding, Equalizing, Roughening · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 15mm · RPM, opt., to: 36000RPM · RPM, opt., from: 26000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Maximum economic efficiency due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process - even under the toughest operating conditions.