Abrasive Sleeve D15xB30mm Grit 60 Aluminum Oxide A max. speed 36000 min-¹ PFERD

Corundum A · for universal use from coarse to fine grinding · Supplied without rubber backing pad · Drive type: straight grinder, flexible shaft drive · Application recommendation: For easy changing of sanding sleeves, slide them on and off with a slight right-hand turn. Leave the sanding sleeve holder clamped in the tool drive. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. For a secure fit of the sanding sleeve, observe the minimum speed of the sanding sleeve holder. · Workable materials: Fiber-reinforced thermosets (GRP, CFRP), brass, bronze, cast steel, aluminum, copper, malleable cast iron, hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC), thermoplastics, gray/spheroidal cast iron (GG/GJL, GGG/GJS), cobalt-based alloys · Machining tasks: Deburring, edge machining, leveling, roughening, sharpening, surface machining, weld seam machining, progressive fine grinding · Ordering information: Please order sanding sleeve holders separately. · Inner Ø: 15mm · RPM, opt., up to: 36000RPM · RPM, opt., from: 26000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow sanding sleeves to protrude beyond the sanding sleeve holder. · Advantages: Maximum cost-effectiveness due to particularly high material removal and high abrasiveness of the abrasive. Outstanding service life due to a special manufacturing process - even under the toughest operating conditions. Secure fit of the sanding sleeve on the sanding sleeve holder due to expansion of the holder during use.