Abrasive sleeve D15xB30mm grit 50 corundum A max. speed 36000 rpm PFERD

Aluminum oxide A · For universal use from coarse to fine grinding · Supplied without rubber holder · Drive type: Die grinder, flexible shaft drive · Application recommendations: For easy changing of abrasive sleeves, slide them on and off with a slight clockwise rotation. Leave the abrasive sleeve holder clamped in the tool drive. Use an abrasive oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. Maintain the minimum speed of the abrasive sleeve holder for a secure fit of the abrasive sleeve. · Workable materials: Bronze, cast steel, cobalt-based alloys, aluminum, malleable cast iron, thermoplastics, brass, copper, fiber-reinforced thermosets (GRP, CFRP), gray/spheroidal cast iron (GG/GJL, GGG/GJS), hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC) · Processing tasks: Weld seam processing, roughening, sharpening, edge processing, leveling, progressive fine grinding, deburring, surface processing · Ordering information: Please order abrasive sleeve holders separately. · Inner diameter: 15mm · RPM, opt., up to: 36000RPM · RPM, opt., from: 26000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to extend beyond the abrasive sleeve holder. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Outstanding service life due to special manufacturing process – even under the toughest operating conditions. Maximum cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive.