Sanding sleeve D15xW30mm grit 150 corundum A max. speed 36000 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · Supplied without rubber backing pad · Drive type: Flexible shaft drive, straight grinder · Application recommendation: To easily change abrasive sleeves, slide them on and off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. For a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. Use an abrasive oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. · Workable materials: Aluminum, gray/spheroidal cast iron (GG/GJL, GGG/GJS), hardened, tempered steels over 1,200 N/mm² (54 HRC) · Processing tasks: Weld seam processing, leveling, edge processing, sharpening, roughening, stepwise fine grinding, deburring, surface processing · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 15mm · RPM, opt., to: 36000RPM · RPM, opt., from: 26000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The stated maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Maximum cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process - even under the toughest operating conditions.