Abrasive Sleeve D13xB25mm Grit 80 Corundum A max. speed 44000 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · supplied without rubber holder · Drive type: Straight grinder, flexible shaft drive · Application recommendation: To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of the abrasive sleeves, pull them on and off with a slight right-hand rotation. Leave the abrasive sleeve holder clamped in the tool drive. For best performance, use at a recommended cutting speed of 20-30 m/s. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. · Workable materials: Stainless steel (INOX), cobalt-based alloys, copper, fiber-reinforced thermosets (GRP, CFRP), thermoplastics, hardened, tempered steels over 1,200 N/mm² (> 54 HRC), steels up to 1,200 N/mm² (< 38 HRC), cast steel, bronze, brass, malleable cast iron, aluminum, grey/spheroidal cast iron (GG/GJL, GGG/GJS) · Processing tasks: Sharpening, leveling, edge processing, deburring, surface processing, roughening, weld seam processing, progressive fine grinding · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 13mm · RPM, opt., up to: 44000RPM · RPM, opt., from: 30000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The stated maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Maximum economic efficiency due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process - even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use.