Abrasive Sleeve D10xB20mm Grit 80 Corundum A max. speed 44000 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · Supplied without rubber backing pad · Drive type: Flexible shaft drive, straight grinder · Application recommendation: For easy changing of abrasive sleeves, twist them on and off with a slight right-hand turn. Leave the abrasive sleeve holder clamped in the tool drive. Use an abrasive oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 20-30 m/s. To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. · Workable materials: Gray/ductile cast iron (GG/GJL, GGG/GJS), aluminum, malleable cast iron, brass, cobalt-based alloys, copper, bronze, hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC), thermoplastics, cast steel, fiber-reinforced thermosets (GRP, CFRP) · Processing tasks: Weld seam processing, edge processing, surface processing, roughening, leveling, progressive fine grinding, deburring, sharpening · Ordering information: Please order abrasive sleeve holders separately. · Inner Ø: 10mm · RPM, opt., up to: 44000RPM · RPM, opt., from: 30000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The specified maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Highest cost-effectiveness due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to a special manufacturing process – even under the toughest operating conditions. Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use.