Abrasive Sleeve D10xB20mm Grit 150 Corundum A max. speed 44000 rpm PFERD

Corundum A · for universal use from coarse to fine grinding · supplied without rubber holder · Drive type: Straight grinders, flexible shaft drives · Recommended application: To ensure a secure fit of the abrasive sleeve, observe the minimum speed of the abrasive sleeve holder. For easy changing of the abrasive sleeves, pull them on and off with a slight clockwise rotation. Leave the abrasive sleeve holder clamped in the tool drive. For best performance, use at a recommended cutting speed of 20-30 m/s. Use an abrasive oil suitable for the material to significantly increase the service life and grinding performance of the tools. · Workable materials: Stainless steel (INOX), aluminum, thermoplastics, steels up to 1,200 N/mm² (54 HRC), hardened and tempered steels over 1,200 N/mm² (<38 HRC), gray/ductile cast iron (GG/GJL, GGG/GJS), fiber-reinforced thermosets (GRP, CFRP), copper, cobalt-based alloys, cast steel, bronze, malleable cast iron, brass · Processing tasks: Surface processing, deburring, progressive fine grinding, leveling, roughening, sharpening, weld seam processing, edge processing · Ordering instructions: Please order abrasive sleeve holders separately. · Inner Ø: 10mm · RPM, opt., up to: 44000RPM · RPM, opt., from: 30000RPM · Safety instructions: The maximum permissible peripheral speed is 30 m/s. The stated maximum permissible speed must never be exceeded for safety reasons. Do not allow abrasive sleeves to protrude beyond the abrasive sleeve holder. · Advantages: Secure fit of the abrasive sleeve on the abrasive sleeve holder due to expansion of the holder during use. Highest economic efficiency due to particularly high material removal and high aggressiveness of the abrasive. Outstanding service life due to special manufacturing process – even under the toughest operating conditions.