Flap Wheel Ø80xH30mm Grit 80 Aluminum Shank-Ø 6 mm PFERD

Corundum A · with abrasive flaps on backing · for universal use from coarse to fine grinding · Shank Ø 6 mm · Also suitable for machining brass, copper and zinc · Shank Ø: 6mm · Drive type: Flexible shaft drive · Straight grinder · Recommended application: Increasing the cutting speed results in a slightly finer surface. Increasing the contact pressure makes the surface slightly coarser. The softer the material to be machined, the coarser the surface (when used) · An increase in removal rate should be achieved by using a coarser grit and not by increasing the contact pressure, in order to prevent unnecessary tool wear and thermal stress on the workpiece. Reducing the contact pressure and peripheral speed, as well as adding grinding oil, reduce tool wear and thermal stress on the workpiece. For best performance, use at a recommended cutting speed of 15–20 m/s. This achieves an ideal compromise between removal rate, surface quality, thermal stress on the workpiece and tool wear. Use a grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. · Machinable materials: Steels up to 1,200 N/mm² (54 HRC, malleable cast iron) · Machining tasks: Surface machining, deburring, progressive fine grinding, texturing (matting, linear matting and satin finishing) · Weld seam machining · Equalizing · Width: 30mm · Note: PFERDERGONOMICS recommends flap wheels · to sustainably reduce vibrations and noise generated during use and to improve working comfort. · Length · Shank: 40mm · RPM · opt.: 4800RPM · Safety instructions: The stated maximum permissible speed must never be exceeded for safety reasons. The contact pressure must be significantly reduced if the stated optimum speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the stated maximum speed for open shank lengths is not exceeded. · Advantages: Optimal contour adaptation due to high flexibility. Consistently high material removal over the entire service life, as new, aggressive abrasive is constantly released. Frontal use very close to edges and in corners possible due to flat cast core construction.