Flap Wheel Ø60xH40mm Grit 120 Aluminum Shank-Ø 6 mm PFERD

Corundum A · With abrasive flaps on a backing pad · For universal use from coarse to fine grinding · Shank Ø 6 mm · Also suitable for processing brass, copper and zinc · Shank Ø: 6mm · Drive type: Straight grinder · Flexible shaft drive · Recommended application: Increased removal rate should be achieved by using a coarser grit, not by increasing the contact pressure, in order to prevent unnecessary tool wear and thermal stress on the workpiece. Reducing the contact pressure and peripheral speed, as well as adding grinding oil, reduce tool wear and thermal stress on the workpiece. Increasing the cutting speed results in a slightly finer surface. Increasing the contact pressure makes the surface slightly coarser. The softer the material to be processed, the coarser the surface (when used) · For best performance, use at a recommended cutting speed of 15–20 m/s. This achieves an ideal compromise between removal rate, surface quality, thermal stress on the workpiece, and tool wear. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. · Workable materials: Gray/spheroidal cast iron (GG/GJL, GGG/GJS), aluminum, malleable cast iron, brass, copper, hardened, tempered steels over 1,200 N/mm² (54 HRC), steels up to 1,200 N/mm² (< 38 HRC), cast steel · Processing tasks: Deburring, gradual fine grinding, leveling, texturing (matting, brush finishing and satin finishing) · Weld seam processing · Surface processing · Width: 40mm · Note: PFERDERGONOMICS recommends flap wheels to sustainably reduce vibration and noise generated during use and to improve working comfort. · Length, shank: 40mm · RPM · opt.: 6300RPM · Safety instructions: The stated maximum permissible speed must never be exceeded for safety reasons. The contact pressure must be significantly reduced if the stated optimum speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the stated maximum speed is not exceeded with open shank lengths. · Advantages: End-face use very close to edges and in corners possible due to flat core construction. Optimal contour adaptation due to high flexibility. Consistently high material removal over the entire service life, as new, aggressive abrasive is continuously released.