Flap Wheel Ø50xH30mm Grit 40 Aluminum Shank-Ø 6 mm PFERD

Corundum A · with abrasive flaps on backing material · for universal use from coarse to fine grinding · shank Ø 6 mm · Also suitable for machining brass, copper and zinc · Shank Ø: 6mm · Drive type: straight grinder · flexible shaft drive · Recommended application: Reducing the contact pressure and peripheral speed as well as adding grinding oil reduce tool wear and the temperature load on the workpiece. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 15–20 m/s. This achieves an ideal compromise between material removal rate, surface quality, temperature load on the workpiece and tool wear. Increasing the cutting speed results in a slightly finer surface. Increasing the contact pressure makes the surface slightly coarser. The softer the material to be machined, the coarser the surface (when used) · An increase in material removal rate should be achieved by using a coarser grit and not by increasing the contact pressure, in order to prevent unnecessary tool wear and temperature load on the workpiece. · Machinable materials: Copper, hardened, tempered steels over 1,200 N/mm² (54 HRC) · Machining tasks: Gradual fine grinding, deburring, leveling, texturing (matting, brush finishing and satin finishing) · Surface finishing · Weld seam finishing · Width: 30mm · Note: PFERDERGONOMICS recommends flap wheels to sustainably reduce vibration and noise generated during use and to improve working comfort. · Length, shank: 40mm · RPM · opt.: 7000RPM · Safety instructions: For safety reasons, the specified maximum permissible speed must never be exceeded. The contact pressure must be significantly reduced if the specified optimal speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the specified maximum speed for open shank lengths is not exceeded. · Advantages: Consistently high material removal over the entire service life, as new, aggressive abrasive is constantly released. Optimal contour adaptation due to high flexibility. Frontal use very close to edges and in angles possible due to flat cast core construction.