Flap Wheel Ø25xH25mm Grit 60 Aluminum Shank-Ø 6 mm PFERD

Corundum A · With abrasive flaps on backing material · For universal use from coarse to fine grinding · Shank Ø 6 mm · Also suitable for processing brass, copper and zinc · Shank Ø: 6mm · Drive type: Die grinder · Flexible shaft drive · Application recommendation: Increasing the cutting speed results in a slightly finer surface. Increasing the contact pressure makes the surface slightly coarser. The softer the material to be processed, the coarser the surface (when used) · For best performance, use at a recommended cutting speed of 15–20 m/s. This achieves an ideal compromise between material removal rate, surface finish, workpiece temperature, and tool wear. An increase in material removal rate should be achieved by using a coarser grit and not by increasing the contact pressure, in order to prevent unnecessary tool wear and temperature exposure of the workpiece. Reducing the contact pressure and peripheral speed, as well as adding grinding oil, reduce tool wear and temperature exposure of the workpiece. Use grinding oil suitable for the material to significantly increase tool life and grinding performance. · Machinable materials: Malleable cast iron, Brass, Gray/spheroidal graphite cast iron (GG/GJL, GGG/GJS), Steels up to 1,200 N/mm² (54 HRC), Copper, Stainless steel (INOX), Hardened, tempered steels over 1,200 N/mm² (< 38 HRC), Aluminum, Cast steel · Processing tasks: Deburring, Equalizing, Texturing (matting, brush finishing and satin finishing), Surface machining, Weld seam machining · Step-by-step fine grinding · Width: 25mm · Note: PFERDERGONOMICS recommends flap wheels to sustainably reduce vibration and noise generated during use and improve working comfort. · Shank length: 40mm · RPM · opt.: 15000RPM · Safety instructions: The stated maximum permissible speed must never be exceeded for safety reasons. The contact pressure must be significantly reduced if the stated optimal speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the stated maximum speed for open shank lengths is not exceeded. · Advantages: Frontal use very close to edges and in corners possible due to flat core construction. Optimal contour adaptation due to high flexibility. Consistently high material removal over the entire tool life, as new, aggressive abrasive is continuously released.