Flap wheel Ø25xH25mm grit 120 aluminum shank-Ø 6 mm PFERD

Corundum A · with abrasive flaps on a backing for universal use from rough to fine grinding · Shank Ø 6 mm · Also suitable for processing brass, copper and zinc · Shank Ø: 6mm · Drive type: Straight grinder · Flexible shaft drive · Application recommendation: Reducing contact pressure and peripheral speed as well as adding grinding oil reduce tool wear and the thermal load on the workpiece. Increasing the cutting speed results in a slightly finer surface. Increasing the contact pressure makes the surface slightly coarser. The softer the material to be machined, the coarser the surface (when used) · Use grinding oil suitable for the material to significantly increase the tool life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 15–20 m/s. This achieves an ideal compromise between material removal rate, surface finish, thermal load on the workpiece and tool wear. An increase in material removal rate should be achieved by using a coarser grit and not by increasing the contact pressure, in order to prevent unnecessary tool wear and thermal load on the workpiece. · Machinable materials: Steel materials with a hardness > 54 HRC, cast steel, aluminum, malleable cast iron, brass, copper, gray/spheroidal cast iron (GG/GJL, GGG/GJS), stainless steel (INOX), steels up to 1,200 N/mm² (< 38 HRC), hardened, tempered steels over 1,200 N/mm² (< 38 HRC) · Machining tasks: Leveling, deburring, surface machining, texturing (matting, linear matting and satin finishing), weld seam machining · Gradual fine grinding · Width: 25mm · Note: PFERDERGONOMICS recommends flap wheels to sustainably reduce vibration and noise generated during use and to improve working comfort. · Length, shank: 40mm · RPM · opt.: 15000RPM · Safety instructions: For safety reasons, the specified maximum permissible speed must never be exceeded. The contact pressure must be significantly reduced if the specified optimal speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the specified maximum speed for open shank lengths is not exceeded. · Advantages: End face use very close to edges and in angles possible due to flat casting core construction. Consistently high material removal over the entire tool life, as new · aggressive abrasive is continuously released. Optimal contour adaptation due to high flexibility.