Flap wheel Ø15xH10mm Grit 80 Corundum Shank Ø 3 mm PFERD

Resin bond · universally applicable · also suitable for processing brass, copper and zinc · Shank-? 3 mm · Shank-Ø: 3mm · Drive type: straight grinder, flexible shaft drive · Application recommendation: Increasing the cutting speed results in a slightly finer surface. Increasing the contact pressure makes the surface slightly coarser. The softer the material to be machined, the coarser the surface (when using, an increase in removal rate should be achieved by a coarser grit and not by increasing the contact pressure, in order to prevent unnecessary tool wear and thermal stress on the workpiece. Reducing the contact pressure and peripheral speed as well as adding grinding oil reduce tool wear and thermal stress on the workpiece. Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 15–20 m/s. This achieves an ideal compromise between removal rate, surface quality, thermal stress on the workpiece and tool wear. · Machinable materials: cast steel, steels up to 1,200 N/mm² (54 HRC · Machining tasks: weld seam processing, deburring, progressive fine grinding, leveling, surface processing, structuring (matting, brush finishing and satin finishing) · Width: 10mm · Note: PFERDERGONOMICS recommends flap wheels to sustainably reduce vibration and noise development during use and to improve working comfort. · Length, shank: 40mm · RPM, opt.: 25000RPM · Safety instructions: The stated maximum permissible speed must never be exceeded for safety reasons. The contact pressure must be significantly reduced if the stated optimal speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the stated maximum speed is not exceeded with open shank lengths. · Advantages: Optimal contour adaptation due to high flexibility. Consistently high material removal over the entire service life, as new, aggressive abrasive is continuously released. Frontal use very close to edges and in corners possible due to flat cast core construction.