Stud anchor FBN II M20xL90mm 20/60 A4 FISCHER

The fischer bolt anchor FBN II is a steel anchor for economic fastenings in uncracked concrete. Thanks to its long thread and two embedment depths, the fischer bolt anchor FBN II is particularly flexible to use. In addition to pre-setting and push-through installation, the bolt anchor is also suitable for stand-off installation. In the stainless steel version, the bolt anchor is suitable for facade substructures, consoles and ladders in outdoor areas. Marketing Claim: The economical fastening made of stainless steel for uncracked concrete. Advantages: The standard embedment depth achieves maximum load-bearing capacities. This means fewer fastening points and smaller anchor plates are required. The reduced embedment depth reduces the drill hole depth. This reduces installation effort and increases flexibility. The long thread allows for compensation of component tolerances and stand-off installations, thus increasing flexibility. Few hammer blows and minimal tightening slippage ensure noticeably easy installation. The impact pin protects the thread from damage, thus ensuring time-saving assembly and disassembly of the attachment part. Top Features: With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means: fewer fastening points and smaller anchor plates. If the reduced embedment depth is used, it reduces the drill hole depth and simplifies installation. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. Easy installation with few hammer blows and minimal slippage. Stainless steel: permanent safety outdoors. Further technical characteristics: · Anchor length: 217mm · Push-through installation: Yes · Thread length: 90mm · Thread size (mm): 20mm · Installation torque: 150Nm · Min. drill hole depth for push-through installation: 195mm · Professional / DIY: Professional · Test mark / approvals: ETA - European Technical Assessment · Wrench size: 30mm · Washer (outer diameter x thickness): 37 x 3mm · Washer (outer diameter x thickness) (1): 37mm · Washer (outer diameter x thickness) (2): 3mm · VDS approval: Yes · Embedment depth hef,max/hef,min: 105 / 80mm · Packaging variant: Folding box · Pre-setting installation: Yes · Max. thickness of attachment part: 60mm · Max. usable length hef,stand./hef,min.: 60 / 85mm Easy installation with few hammer blows and minimal slippage. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means: fewer fastening points and smaller anchor plates. Stainless steel: permanent safety outdoors. If the reduced embedment depth is used, it reduces the drill hole depth and simplifies installation.