Fischer FBN II M16x74mm 16/10 A4 Bolt Anchor

The fischer bolt anchor FBN II is a steel anchor for economic fastenings in uncracked concrete. Thanks to its long thread and two embedment depths, the fischer bolt anchor FBN II is particularly flexible to use. In addition to pre-positioned and push-through installation, the bolt anchor is also suitable for stand-off installation. In the stainless steel version, the bolt anchor is suitable for facade substructures, consoles and ladders outdoors. Marketing Claim: The economical stainless steel fastening for uncracked concrete. Advantages: The standard embedment depth achieves maximum load-bearing capacities. This means fewer fastening points and smaller anchor plates are required. The reduced embedment depth reduces the drill hole depth. This reduces installation effort and increases flexibility. The long thread allows for compensation of component tolerances and stand-off installations, thus increasing flexibility. Few hammer blows and minimal tightening slip ensure noticeably easy installation. The impact pin protects the thread from damage, thus ensuring time-saving installation and removal of the attached component. Top Features: With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means: fewer fastening points and smaller anchor plates. If the reduced embedment depth is used, this reduces the drill hole depth and simplifies installation. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. Easy installation with few hammer blows and minimal slip. Stainless steel: permanent safety outdoors. Further technical properties: · Anchor length: 128mm · Push-through installation: Yes · Thread size (mm): 16mm · Installation torque: 80Nm · Min. drill hole depth for push-through installation: 114mm · Pro / DIY: Pro · Test mark / approvals: ETA - European Technical Assessment · Wrench size: 24mm · Washer (outer diameter x thickness): 30 x 3mm · Washer (outer diameter x thickness) (1): 30mm · Washer (outer diameter x thickness) (2): 3mm · VDS approval: Yes · Embedment depth hef,max/hef,min: 80 / 65mm · Packaging variant: Folding carton · Pre-positioned installation: Yes · Max. thickness of attached part: 10mm · Max. usable length hef,stand./hef,min.: 10 / 25mm Easy installation with few hammer blows and minimal slip. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means: fewer fastening points and smaller anchor plates. Stainless steel: permanent safety outdoors. If the reduced embedment depth is used, this reduces the drill hole depth and simplifies installation.