Bolt anchor FBN II M12x149mm 12/100 FISCHER

The fischer bolt anchor FBN II is a steel anchor for economic fastenings in non-cracked concrete. Thanks to its long thread and two embedment depths, the fischer bolt anchor FBN II is particularly flexible to use. In addition to push-through and pre-positioned installation, the bolt anchor is also suitable for stand-off installation. In the electro-galvanized steel version, the bolt anchor is suitable for railings, cable trays, and consoles indoors. Marketing Claim: The economical fastening for flexible use in non-cracked concrete. Advantages: The standard embedment depth achieves maximum load-bearing capacities. This requires fewer fastening points and smaller anchor plates. The reduced embedment depth decreases the drill hole depth. This reduces installation effort and increases flexibility. The long thread allows for compensation of component tolerances and stand-off installations, thus increasing flexibility. A few hammer blows and minimal slip ensure noticeably easy installation. The impact pin protects the thread from damage, ensuring time-saving installation and removal of the attached component. Top Features: With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means: fewer fastening points and smaller anchor plates. If the reduced embedment depth is used, it reduces the drill hole depth and simplifies installation. Component tolerances are compensated with the long thread. Furthermore, the FBN II is suitable for stand-off installations. This increases flexibility. Easy installation with a few hammer blows and minimal slip. Further technical properties: · Anchor length: 194mm · Push-through installation: Yes · Thread size (mm): 12mm · Installation torque: 50Nm · Min. drill hole depth for push-through installation: 185mm · Pro / DIY: DIY/Pro · Test mark / Approvals: ETA - European Technical Assessment · Wrench size: 19mm · Washer (outer diameter x thickness): 18 x 2mm · Washer (outer diameter x thickness) (1): 18mm · Washer (outer diameter x thickness) (2): 2mm · VDS approval: Yes · Embedment depth hef,max/hef,min: 65 / 50mm · Packaging variant: Folding box · Pre-positioned installation: Yes · Max. thickness of attached component: 100mm · Max. usable length hef,stand./hef,min.: 100 / 115mm Easy installation with a few hammer blows and minimal slip. Impact pin protects thread from damage. This saves time during installation and removal. Component tolerances are compensated with the long thread. Furthermore, the FBN II is suitable for stand-off installations. This increases flexibility. With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means: fewer fastening points and smaller anchor plates. If the reduced embedment depth is used, it reduces the drill hole depth and simplifies installation.