Through-bolt FBN II M D6xL35mm 6/30 FISCHER

The fischer stud anchor FBN II is a steel anchor for economic fastenings in non-cracked concrete. Thanks to its long thread and two embedment depths, the fischer stud anchor FBN II is particularly flexible to use. In addition to push-through and pre-positioned installation, the stud anchor is also suitable for stand-off installation. In the electro-galvanised steel version, the stud anchor is suitable for railings · cable trays · brackets in interior areas. Marketing Claim: The economical fastening for flexible use in non-cracked concrete. Advantages: The standard embedment depth achieves maximum load-bearing capacities. This means fewer fastening points and smaller anchor plates are required. The reduced embedment depth reduces the drill hole depth. This minimises installation effort and increases flexibility. The long thread allows for compensation of component tolerances and stand-off installations, thus increasing flexibility. A few hammer blows and minimal slip ensure noticeably easy installation. The drive-in pin protects the thread from damage, thus ensuring time-saving assembly and disassembly of the attachment. Top Features: With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means: fewer fastening points and smaller anchor plates. If the reduced embedment depth is used, this reduces the drill hole depth and simplifies installation. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. Easy installation with a few hammer blows and minimal slip. Further technical properties: · Anchor length: 75mm · Push-through installation: Yes · Thread size (mm): 6mm · Installation torque: 7.5Nm · Min. drill hole depth for push-through installation: 70mm · Professional / DIY: Professional · Test mark / approvals: ETA - European Technical Assessment · Wrench size: 10mm · Washer (outer diameter x thickness): 12 x 1.6mm · Washer (outer diameter x thickness) (1): 12mm · Washer (outer diameter x thickness) (2): 1.6mm · VDS approval: Yes · Embedment depth hef,max/hef,min: 30 / -mm · Packaging variant: Folding carton · Pre-positioned installation: Yes · Max. thickness of the attachment: 30mm · Max. usable length hef,stand./hef,min.: 30 / -mm Easy installation with a few hammer blows and minimal slip. Drive-in pin protects thread from damage. This saves time during assembly and disassembly. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility.