Bolt anchor FBN II dia. 8mm L.91mm Head marking: F stainless steel FISCHER

The fischer bolt anchor FBN II is a steel anchor for economical fastenings in uncracked concrete. Thanks to its long thread and two embedment depths, the fischer bolt anchor FBN II is particularly flexible to use. In addition to push-through and pre-positioned installation, the bolt anchor is also suitable for stand-off installation. In the stainless steel version, the bolt anchor is suitable for facade substructures, brackets, and ladders in outdoor areas. Marketing Claim: The economical stainless steel fastening for uncracked concrete. Advantages: The standard embedment depth achieves maximum load capacities. This means fewer fastening points and smaller anchor plates are required. The reduced embedment depth lowers the drill hole depth, which decreases installation effort and increases flexibility. The long thread allows for compensation of component tolerances and stand-off installations, thus increasing flexibility. Few hammer blows and minimal tightening slip ensure noticeably easy installation. The impact pin protects the thread from damage, ensuring time-saving installation and removal of the attached part. Top Features: With the standard embedment depth, the FBN II achieves maximum load capacity. This means fewer fastening points and smaller anchor plates. If the reduced embedment depth is used, it lowers the drill hole depth and simplifies installation. The long thread compensates for component tolerances. In addition, the FBN II is suitable for stand-off installations, increasing flexibility. Easy installation with few hammer blows and minimal slip. Stainless steel: permanent safety outdoors. Further technical characteristics: · Anchor length: 90mm · Push-through installation: Yes · Thread size (mm): 8mm · Installation torque: 10Nm · Min. drill hole depth for push-through installation: 86mm · Professional / DIY: Professional · Test mark / approvals: ETA - European Technical Assessment · Wrench size: 13mm · Washer (outer diameter x thickness): 16 x 1.6mm · Washer (outer diameter x thickness) (1): 16mm · Washer (outer diameter x thickness) (2): 1.6mm · VDS approval: Yes · Embedment depth hef,max/hef,min: 40 / 30mm · Packaging variant: Folding box · Pre-positioned installation: Yes · Max. thickness of attached part: 30mm · Max. usable length hef,stand./hef,min.: 30 / 40mm Easy installation with few hammer blows and minimal slip. The long thread compensates for component tolerances. In addition, the FBN II is suitable for stand-off installations, increasing flexibility. With the standard embedment depth, the FBN II achieves maximum load capacity. This means fewer fastening points and smaller anchor plates. Stainless steel: permanent safety outdoors. If the reduced embedment depth is used, it lowers the drill hole depth and simplifies installation.