Bolt Anchor FBN II Dia. 12mm Length 146mm Head Embossing: S hot-dip galvanized FISCHER

The fischer bolt anchor FBN II is a steel anchor for economic fastenings in uncracked concrete. Thanks to its long thread and two anchorage depths, the fischer bolt anchor FBN II is particularly flexible to use. In addition to pre-positioned and push-through installation, the bolt anchor is also suitable for stand-off installation. In the stainless steel version, the bolt anchor is suitable for facade substructures, consoles and ladders in outdoor areas. Marketing Claim: The economical fastening made of hot-dip galvanized steel in uncracked concrete. Advantages: The standard anchorage depth achieves maximum load capacities. This means fewer fastening points and smaller anchor plates are required. The reduced anchorage depth reduces the drill hole depth. This reduces installation effort and increases flexibility. The first hot-dip galvanized bolt anchor with variable service life covers the permissible use of the bolt anchor in damp environments and outdoors. The long thread allows compensation for component tolerances and stand-off installations, thus increasing flexibility. Few hammer blows and minimal tightening slippage ensure noticeably easy installation. The impact pin protects the thread from damage, thus ensuring time-saving assembly and disassembly of the attachment. Top Features: With ETA assessment for the hot-dip galvanized version with variable service life outdoors, depending on corrosion conditions. With the standard anchorage depth, the FBN II achieves maximum load capacity. This means: fewer fastening points and smaller anchor plates. If the reduced anchorage depth is used, this reduces the drill hole depth and simplifies installation. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. Easy installation with few hammer blows and minimal slippage. Further technical properties: · Anchor length: 144mm · Push-through installation: Yes · Thread length: 99mm · Thread size (mm): 12mm · Installation torque: 50Nm · Min. drill hole depth for push-through installation: 135mm · Professional / DIY: Professional · Test mark / approvals: ETA - European Technical Assessment · Wrench size: 19mm · Washer (outer diameter x thickness): 18 x 2mm · Washer (outer diameter x thickness) (1): 18mm · Washer (outer diameter x thickness) (2): 2mm · VDS approval: Yes · Anchorage depth hef,max/hef,min: 65 / 50mm · Packaging variant: Folding box · Pre-positioned installation: Yes · Max. thickness of attachment: 50mm · Max. effective length hef,stand./hef,min.: 50 / 65mm Easy installation with few hammer blows and minimal slippage. Impact pin protects thread from damage. This saves time during assembly and disassembly. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. With the standard anchorage depth, the FBN II achieves maximum load capacity. This means: fewer fastening points and smaller anchor plates. If the reduced anchorage depth is used, this reduces the drill hole depth and simplifies installation.