Bolt Anchor FBN II D. 10mm Length 126mm Head Marking: S hot-dip galvanized FISCHER

The fischer bolt anchor FBN II is a steel anchor for economical fixings in uncracked concrete. Thanks to its long thread and two embedment depths, the fischer bolt anchor FBN II is particularly flexible to use. In addition to pre-positioned and push-through installation, the bolt anchor is also suitable for stand-off installation. In the stainless steel version, the bolt anchor is suitable for facade substructures, brackets, and ladders in outdoor areas. Marketing Claim: The economical fixing made of hot-dip galvanized steel in uncracked concrete. Advantages: The standard embedment depth achieves maximum load-bearing capacities. This means fewer fixing points and smaller anchor plates are required. The reduced embedment depth reduces the drill hole depth. This reduces installation effort and increases flexibility. The first hot-dip galvanized bolt anchor with variable service life covers the permissible use of the bolt anchor in damp environments and outdoors. The long thread allows for compensation of component tolerances and stand-off installations, thus increasing flexibility. Few hammer blows and minimal slip ensure noticeably easy installation. The drive-in pin protects the thread from damage, ensuring time-saving assembly and disassembly of the attachment. Top Features: With ETA assessment for the hot-dip galvanized version with variable service life outdoors, depending on corrosion conditions. With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means fewer fixing points and smaller anchor plates. If the reduced embedment depth is used, it reduces the drill hole depth and simplifies installation. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. Easy installation with few hammer blows and minimal slip. Further technical properties: · Anchor length: 125mm · Push-through installation: Yes · Thread length: 86mm · Thread size (mm): 10mm · Installation torque: 30Nm · Min. drill hole depth for push-through installation: 118mm · Professional / DIY: Professional · Test marks / approvals: ETA - European Technical Assessment · Wrench size: 17mm · Washer (outer diameter x thickness): 20 x 2mm · Washer (outer diameter x thickness) (1): 20mm · Washer (outer diameter x thickness) (2): 2mm · VdS approval: Yes · Embedment depth hef,max/hef,min: 50 / 40mm · Packaging variant: Folding box · Pre-positioned installation: Yes · Max. thickness of attachment: 50mm · Max. usable length hef,stand./hef,min.: 50 / 60mm Easy installation with few hammer blows and minimal slip. Drive-in pin protects thread from damage. This saves time during assembly and disassembly. Component tolerances are compensated with the long thread. In addition, the FBN II is suitable for stand-off installations. This increases flexibility. With the standard embedment depth, the FBN II achieves maximum load-bearing capacity. This means fewer fixing points and smaller anchor plates. If the reduced embedment depth is used, it reduces the drill hole depth and simplifies installation.